Page 7 of 7
HARDWARE: Controls (Left): STAGE 1 MOD (Manual)
STAGE 2 MOD (Manual)
STAGE 3 MOD (Manual)
INPUT GAIN/ATTEN
Controls (Right): STAGE 1 CV (External)
STAGE 2 CV (External)
STAGE 3 CV (External)
OUTPUT GAIN/ATTEN
Inputs (Signal): 1x DC, approx. +/-10V max. (3.5mm mono socket)
Inputs (CV): 3x DC, approx. +/-10V max. (3.5mm mono socket)
Outputs (Signal): 1x DC FULL-WAVE (3.5mm mono socket)
1x DC HALF-WAVE (3.5mm mono socket)
Power Requirements: +/-12V via 16-pin, Doepfer-style IDC connector
Current Draw: 80mA average
Dimensions: 10HP (W); panel to IDC connector 35mm (D)
Supplied Accessories: 1x 16-pin, Doepfer-style cable, 4x M3 screws
CALIBRATION: AC-coupled inputs and outputs (i.e. most inputs and outputs that are used
for AC and ‘audio’ signals) use a capacitor to remove constant DC content,
leaving only the AC content of the waveform.
The inputs and outputs of the ADE-10 are DC-coupled, which allows it to use
both audio and CV signals (AC and DC) such as LFOs, gates, triggers, etc.
as input and external CV input signals - but please note that any DC content
present at the input will also be present at the output.
Additionally, a non-calibrated ADE-10 can also add a small amount of DC
content to the output waveform.
Each ADE-10 is calibrated before shipping and once set, the output should
remain at close to 0V DC with all front panel controls set to 0% and no
inputs connected.
For advice on calibrating the ADE-10 please contact Abstract Data.
PRECAUTIONS: The ADE-10 uses the Doepfer standard for power connection and cable
orientation. The RED stripe on the supplied power cable connects to the
NEGATIVE (-12V) rail on the ADE-10 with the RED stripe facing DOWN.
This is marked on the back of the ADE-10 PCB as “-12 RED”.
(Please see ‘POWER CONNECTOR’ on page 3 of this guide)
The ADE-10 has diode and polyfuse protection built in but an incorrectly
connected cable may still cause damage to the module or the power supply.
The rear panel of the ADE-10 has exposed parts and connections. Please
ensure when handling the ADE-10 that the unit is held by the sides of the
front panel or the sides of the PCB.
CREDITS: Dr. Zoe Healey
Rory Dow
Matrix
© 201
1
Abstract Data Ltd.
http://www
.abstractdata.biz
[email protected] V
ersion 1.0 October 201
1
7: Technical
(4 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales